Kenmore Vacuum Cleaner
Kenmore vacuum offers a variety of options to provide the cleanest carpets with a limited amount of hassle. Knowing how to properly adjust and use your vacuum cleaner will ensure that you get the most out of it. There are many different models, but their basic functions are very similar.
How to use a Kenmore Vacuum Cleaner?
- Connect the vacuum tubes and hold the handle. Insert "Energy-Mate" tubes and connect the "Power-Mate" plug for the rod assembly.
- Open the cylinder hood and check for proper vacuum bag installation. Check that the motor safety filter is clean and unrestricted. Remove the bag by deactivating the cardboard mounting tab of the red bag and pulling the bag out of the can. The engine filter is located under the bag. Clean the filter and install a new bag by inserting its cardboard tab into the red bag mount. Consult your manual bag vacuum cleaner-complete installation and filter cleaning procedures.
- Align the cap of the hose and the notch in the cap cartridge to insert the vacuum hose. Push in until it clicks into place.
- Pull the desired length of cord from the reservoir and plug into a standard 120V outlet located near floor level.
- Step on the handle release pedal to lower the rod or handle, from its vertical position.
- Use the small foot pedal to select the appropriate pile height setting for your rugs. "XLO" is good for short carpets and exposed floors, "LO" and "MED" for low and medium length carpets and "HI" shag and more carpets.
- Turn the vacuum on by hooking the switch on the handle of the wand. Void pushing the "Power Mate" forward and pulling back towards you in slow, controlled motions.
Tips & Tricks
- Use the different provides accessories to clean various surfaces and hard-to-reach areas. Simply disconnect the tubing and attach the handle and the appropriate accessory.
- Do not use the vacuum cleaner on large objects that could obstruct the vacuum, or fine powders, dust, or lint. All of these items could lead to your vacuum bag bursting prematurely.
How to clean a Kenmore vacuum?
A dirty filter can decrease the vacuum’s suction and cause poor dirt pickup, according to the Kenmore manual. Regular cleaning and clog removal prevents dirt from accumulating and keeps your vacuum cleaner at its best. Cleaning the exterior of your vacuum cleaner reduces static electricity, which attracts dust. If your best vacuum cleaner doesn’t pick up dirt like it did in the past, find a time to give it a thorough cleaning.
- Make sure the vacuum cleaner is not plugged into an electrical outlet. Do not clean the vacuum while it is on.
- Wipe the exterior of the vacuum cleaner with a cloth dampened in warm soapy water. Be sure to wring out the rag to remove excess liquid. Drops of water in the vacuum can damage the unit.
- Dry the vacuum cleaner with a dry cloth.
- Clean accessories with soapy water. Rinse accessories and allow to dry completely before use. Accessories should not be placed in the dishwasher.
- Open the dust bag cover and remove the dust bag. Remove the dirt that has accumulated in the area where the vacuum bag is connected. If the engine filter (located under the bag) is dirty, wash it with soapy water. Rinse with clean water, squeeze out excess water and allow to dry completely before returning to vacuum. Insert a new bag and close the lid.
- Turn the vacuum over and remove the fibers or particles that have accumulated on the beater bar. Use scissors to remove chains or hair that have wrapped around the beater bar.
Tips and Warnings
If the vacuum uses a HEPA filter, do not try to clean the filter. A dirty HEPA filter must be completely replaced. Cleaning a HEPA filter disables its ability to capture dust. Make sure the vacuum cleaner and all its parts are completely dry before plugging into an outlet.
Read more about the best vacuum for luxury vinyl plank floors to use them in your home or commercially.