How to Clean a Vacuum Cleaner Filter?
How to clean a vacuum cleaner filter?
Preventive maintenance program: maintaining a vacuum cleaner
The key to optimal vacuum maintenance is to always adhere to good use and cleaning practices. Here we will see what these good practices. Let’s dig the further details on how to clean a vacuum cleaner filter?
Good practices
It is important to keep the vacuum cleaner unplugged while it is not being used; in this way problems arising from inadvertent start-up are prevented. In addition, the unit should be kept in a dry and humid place, away from the work site and preferably inside a protective cover against dust and humidity.
When using it, always remember to check the interior to make sure it is clean and in working condition. Connect the vacuum cleaner to the mains only after checking that the filters are in place and that the receptacle is properly closed.
After use, unplug the unit, empty the tank, rinse it and clean it with a soft cloth with a little neutral shampoo. Dry it with a clean cloth, and leave it open for a few moments to allow all the moisture to evaporate. Store the unit with the cord properly coiled, away from the bustle of the work area.
General maintenance
The general maintenance cycle consists of a more thorough cleaning than is carried out on a daily basis. It is necessary to first empty the tank (can be achieved with the reverse cycle) and then unplug the unit. The cover must then be removed for disassembly, inspection, and cleaning.
Inspecting a vacuum cleaner
The first step in maintaining a vacuum for luxury vinyl plank floors is taking the unit apart for inspection. For this, consult the manual to find out which parts can be disassembled by the user. Remember: you should never disassemble a component that is not designed for it.
In general, best vacuum cleaners can be disassembled into four main components: hoses and accessories, tank, filters and cover. This last part is the one that contains the motor and most of the electrical circuits.
Check hoses and fittings for bumps, holes, and other breaks. If found, discard the hose or fitting as they cannot be repaired.
Inspection of the tank can find adhering dirt, bumps, rust and scratches. If the container is plastic, look for holes or cracks. If it is stainless steel, it is difficult but not impossible for holes to exist.
Detach the filter and observe its appearance after cleaning: if it is green or yellowish in color, it must be replaced. The same happens if it acquired a dark color. In any case, check it with a magnifying glass to see if its surface appears smooth or if it has fluff; in the latter case, replace it.
Lastly, carefully inspect the cap for dirt, stains, dings, and cracks. In the event of bumps or cracks, you must take the unit to an authorized technical service.
How to clean the filter of a vacuum cleaner?
The filters for these best vacuum cleaners are made with a special type of paper, which is porous to allow air to pass through, but whose holes are tiny, to prevent the passage of any dust or liquid particles. For this reason, the filter should only be cleaned with water (if possible distilled or softened to remove calcium minerals) and a neutral detergent. No other product should be used for cleaning, as most solvents and chemical cleaners will damage the delicate porous structure of the paper, ruining it.
Cleaning the chassis and fan of a vacuum cleaner
The chassis (or casing) is the box that protects the motor and electrical circuits. It is generally made of injected plastic and contains nozzles and other parts that can be movable. The maintenance of a vacuum requires that these can also be properly cleaned.
For the correct cleaning of this component, the use of dry cleaning foams and a soft cloth is recommended.
The same recommendation applies to cleaning the fan, although an old toothbrush can be used to remove stubborn dirt in the corners, as long as its bristles do not scratch the plastic.
